Not sure if that is important.Ĭ:/Users/someguy/Documents/test/Test.scr, Line 56:Ĭ:/Users/someguy/Documents/test/Test.scr, Line 61:Ĭ:/Users/someguy/Documents/test/Test.scr, Line 63:Ĭ:/Users/someguy/Documents/test/Test.scr, Line 64: The first occurred when it appeared to be 75% complete. The following errors occurred on only one part. Lost count of how many errors occurred but they were all similar to this below This is indicative of multiple tests I've run, including a larger schematic with multiple parts. Imported as you outline however the component generate multiple errors. I exported from Altium (Save Project as - PCAD V16 ASCII). So much so that I generated a simple test with 1 component schematic (cer cap - C0603). Hundreds of errors on larger single sheet schematics. I seem to be able to get wires from my imported schematic but almost every part generates multiple errors when importing. Symbols/Passives/SCH - PASSIVES - CAPACITOR.I've been attempting what I think is your suggestions with not much success. Table 106 Capacitors - SMD Ī descritption make the usage of the component easier to the designerįootprints/Capacitor - Chip/PCB - CAPACITOR - CHIP - CAPC_0603.PCBLIB The table cells, which are here described in detail is from “Capacitors - SMD” table as an example. Press OK and fill out the missing cell (in this example, “ComponentLink1Description”). See Symbols and Footprints on how to extract the symbol from different sources. The schematic symbols are located under alitum_libraries\symbols If the schematic does not exist, copy the schematic symbol in the suitable directory under alitum_libraries\symbols. In case of doubt the symbol and the footprint supplied by the manufacturer must be used instead of using an existing footprint.Ĭheck if the schematic symbol already exists as a symbol in the Bitbucket system. The mapping of the pins is done with the pin numbering (pin 1 of the symbol is mapped to pin 1 of the footprint and so on). The number of pins on the symbol must match the number of pins on the footprints. Only if the component has a different geometry or pinout, a new schematic and/or footprint must be added. This means that schematics and footprints symbols of generic components only have to be in the Bitbucket repository once, even if there are multiple physical components available (e.g. The goal of this database system is that schematic and footprints of generic components only exist once.
0 kommentar(er)
